Have to manually enable deposits because your system doesnt allow us to Keep the deposit request setting ON and just turn it off for individual estimates- it forces us to turn it back on. When you set your deposit settings for future estimates, you should be able to Turn it off individually for any estimate you want and have it not overwrite your future estimate deposit settings. Intuitively, when you check off "apply for future estimates" all future estimates should have the deposit amount you requested. However in your system, if you turn it off for ONE estimate, even if you do not check off the box to Apply the 0% deposit request for future estimates, it turns it off for all future estimates. Resolving this will resolve the OTHER development issue I am about to outline- Your system has a setting causing ACH to not be allowed when the total amount requested is less than $100. This is intended. However, since that means that if you opened an estimate and your deposit request was at 0% because the "save deposit amount for future estimates" deactivated itself when you wrote your last estimate (Most commercial clients dont pay deposits on services unless theyre quite large contracts so this is a necessity for many of us), you now have an estimate that has a deposit amount LOWER than the minimum ACH requirement. When you then add a deposit request, ACH request is Not activated even if you have the "Automatically allow ACH payment on all transactions" setting on. This seems like a minor inconvenience but it means two things that should be automatic now require manual amendment on 10-20 transactions a day at times.
